- Pack
ADAPTABLE RUNNER RENAULT R4 FOR 1 WINDOW PLASTIC FRAME
Adaptable window runner for RENAULT R4 plastic frames
This kit includes: the flocked window run and the rubber cover profile for a single window.
Dismantling instructions :
1/ Unstrap the frame.
2/ Remove the door frame.
3/ Remove the glass.
4/ Remove the runner from its plastic support.
5/ Clean the glass and slide support assembly with water and a non-aggressive product such as washing-up liquid. Then dry the assembly well.
Assembly instructions :
1/ Place the runner at the bottom, starting from the water drain hole.
2/ When you reach the end of the glass closer guide, insert the rubber profile under the collar and continue to fill the assembly until the beginning of the glass closer guide. Then continue with the runner only until you reach the water drainage hole.
3/ It is possible to make openings in the other two drainage holes.
4/ To hold the runner in place at the joint, you can apply two dots of polyurethane glue.
5/ Replace the glass.
6/ Replace the frame in its housing on the door.
7/ Fit the staples (reference: AGRAFE008), not included in the kit.
Public Price:
€34.90Privilege card price:
€31.41Your Price :
You might also like
WINDSCREEN SEAL FOR PEUGEOT 203 SALOON
Public Price:
€49.90Privilege card price:
€49.90Your Price :
REAR WINDOW GASKET PEUGEOT 203 CURVED GLASS (LARGE)
Public Price:
€33.20Privilege card price:
€33.20Your Price :
REAR WINDOW SEAL PEUGEOT 203 ESTATE
Public Price:
€42.70Privilege card price:
€38.43Your Price :
REAR WINDOW SEAL PEUGEOT 203 SMALL FLAT GLASS
Public Price:
€37.30Privilege card price:
€33.57Your Price :
WINDOW WASHERS THE COMPLETE CAR KIT PEUGEOT 203 and 403 (sedans)
Public Price:
€54.90Privilege card price:
€49.41Your Price :
FRONT WINDOW JAMB SEAL RENAULT ESTAFETTE
Public Price:
€3.60Privilege card price:
€3.24Your Price :
CHROME FLAT REAR LENS AND WINDSCREEN KEY (Sold by ML)
Public Price:
€8.00Privilege card price:
€7.20Your Price :
Description
Adaptable window runner for RENAULT R4 plastic frames
This kit includes: the flocked window run and the rubber cover profile for a single window.
Dismantling instructions :
1/ Unstrap the frame.
2/ Remove the door frame.
3/ Remove the glass.
4/ Remove the runner from its plastic support.
5/ Clean the glass and slide support assembly with water and a non-aggressive product such as washing-up liquid. Then dry the assembly well.
Assembly instructions :
1/ Place the runner at the bottom, starting from the water drain hole.
2/ When you reach the end of the glass closer guide, insert the rubber profile under the collar and continue to fill the assembly until the beginning of the glass closer guide. Then continue with the runner only until you reach the water drainage hole.
3/ It is possible to make openings in the other two drainage holes.
4/ To hold the runner in place at the joint, you can apply two dots of polyurethane glue.
5/ Replace the glass.
6/ Replace the frame in its housing on the door.
7/ Fit the staples (reference: AGRAFE008), not included in the kit.