WATER PUMP SIMCA 1000 1st Model, Motor 315
Water pump for SIMCA 1000 with motor 315
Height of the fixing body: 100mm
Inlet and outlet outside diameter: 29mm
Heating outside diameter: 17mm
Original reference: OEM: 24737L
Vehicle allocation:
SIMCA:
1000: 315 engine
1000 Bertone Coupé
ASSEMBLY INFORMATION:
First and foremost install without constraint (do not tap with a hammer for example to drive the pulley on the shaft) the water pump drive pulley (belt pulley).
Proceed immediately after torque tightening of the supplied lock nut. Once the pulley is in place and tightened, install the fan bellows holder and the cooling fan also without constraint, then torque tighten the supplied lock nut.
If the mounting direction is not respected, there will be a risk of leakage due to the breakage of one of the seals inside the water pump.
Public Price:
€349.90Privilege card price:
€349.90Your Price :
You might also like
SIMCA 1000 WATER PUMP KIT (Seal - 2 bearings - 2 rings)
Public Price:
€60.40Privilege card price:
€54.36Your Price :
COOLING LIQUID -25°, 5 LITER CONTAINER
Public Price:
€10.90Privilege card price:
€10.90Your Price :
WATER PUMP GASKET PEUGEOT 204, 304 and 305
Public Price:
€4.30Privilege card price:
€3.87Your Price :
WATER PUMP PEUGEOT 403, 15 mm axle, Disengageable
Public Price:
€299.90Privilege card price:
€269.91Your Price :
WATER PUMP PEUGEOT 203 and 403 15 mm shaft, non-disengageable
Public Price:
€319.90Privilege card price:
€287.91Your Price :
WATER PUMP GASKETS, the 2 - RENAULT R4, R5, R6
Public Price:
€6.90Privilege card price:
€6.21Your Price :
RENAULT JUVA 4 and DAUPHINOISE WATER PUMP SEALS
Public Price:
€5.90Privilege card price:
€5.31Your Price :
Description
Water pump for SIMCA 1000 with motor 315
Height of the fixing body: 100mm
Inlet and outlet outside diameter: 29mm
Heating outside diameter: 17mm
Original reference: OEM: 24737L
Vehicle allocation:
SIMCA:
1000: 315 engine
1000 Bertone Coupé
ASSEMBLY INFORMATION:
First and foremost install without constraint (do not tap with a hammer for example to drive the pulley on the shaft) the water pump drive pulley (belt pulley).
Proceed immediately after torque tightening of the supplied lock nut. Once the pulley is in place and tightened, install the fan bellows holder and the cooling fan also without constraint, then torque tighten the supplied lock nut.
If the mounting direction is not respected, there will be a risk of leakage due to the breakage of one of the seals inside the water pump.